Shopping Cart
Your cart is empty.
Browse Categories


Winchester 97 Trench Gun Bayonet lug & Heat Shield w/ Screws

Price: $113.95
Out Of Stock - Some Items Can Be Backordered. Call To Find Out If This Is One.
Item Number: W97058
PLEASE NOTE: These will only fit original Winchester 97s with the correct grooves cut - If your barrel does not have the grooves cut for the screws, they will have to be machined. These will not fit reproduction Winchester 97s currently on the market. Will ONLY fit P14 & P17 bayonets.

Tell Us What You Think About This Product

(12 Ratings, 6 Reviews) Average Rating:
Quality product
Lucas McGrail (Livonia, MI) 1/26/2017 9:26 PM
I have a WWII era Stevens trench gun which at some point had the shield removed. Although the listing doesn't say it, this repro can fit as Stevens. You have to use flat head screw drivers as shims to widen the muzzle covering. Then rub lithium grease or similar on the muzzle and the inside of the covering. Set the butt on a carpeted or padded floor, then slowly tap it with a rubber mallet while pulling down with your other hand. Then just spot the machined notches on the muzzle to line up with the covering. The screws will not fit all the way in but almost all the way.
Fit and finish way better than IMA
Michael Langrall (Chesapeake, VA) 1/6/2015 8:58 AM
I bought one from IMA, I sent it back, it was a piece of junk, I could have made one that looked better in my garage. Sarco's heat shield fit nicely on my Stevens 520 clone, which has a cut down barrel, I would defiantly recommend this product.
Warr (Land of Lincoln) 6/10/2012 9:00 PM
I put this on a Norinco model 1897 riot gun and transformed it into a trench gun or I should say my gunsmith did, the end result was a perfect fit. If you are not sure about this fitting a NORINCO 97, it does.
Trench Gun Bayonet lug & Heat Shield
Eldorado (SOUTH BEND, IN) 11/8/2011 3:41 AM
Fits perfectly on a NORINCO clone M97 Riot Gun. Takes a bit of careful measuring and work with a Dremel tool (or similar) to make the three shallow clearance grooves on the underside of the barrel for the pinch screws, but otherwise a straight forward bolt-on. Very pleased with the quality, appearance, fit and the price.
Winchester 97 Trench Gun Bayonet lug & Heat Shield w/ Screws
Carnivorous Vulgaris (Texas) 3/12/2011 8:06 PM
The item is well made and nicely finished HOWEVER it will not properly fit a riot gun barrel without modification. The sleeve for the barrel is too small to fit over the end of the barrel and the hole for the magazine end cap is also too small. It will fit a cut down "bird gun" barrel no problem.
Mailing Lists